Menu

Ex VAT

32mm and 40mm waste pipe sizes: which for basin, sink and bath

Which waste pipe size suits a basin, sink, bath or shower, what 32mm and 40mm pipe clips are for, and the parts to buy for a basin and a kitchen sink.

Which waste pipe size do I need: 32mm or 40mm?

Use 32mm for a basin and 40mm for a sink, bath, shower or appliance. Waste pipe in the range comes in both sizes, in push fit and in solvent weld, in white or black. The toilet stack is a separate system at 110mm, in the above-ground category.

Appliance Pipe Longest branch Fall Clip spacing
Basin, bidet 32mm 1.7m 18 to 90mm per metre 500mm horizontal, 1.2m vertical
Sink, bath, shower 40mm 3m 18 to 90mm per metre 500mm horizontal, 1.2m vertical
Washing machine, dishwasher 40mm 3m 18 to 90mm per metre 500mm horizontal, 1.2m vertical

Aim for 20mm of fall per metre, which sits inside the range with room to spare. Set it with a 1m spirit level and a 20mm packer under one end. Our push fit or solvent weld guide has the full table, and the soil pipe guide covers the 110mm stack these waste pipes run to.

What are 32mm pipe clips best for?

The 32mm Pipe Clip holds 32mm waste pipe to the wall, which is the basin size. The 40mm Pipe Clip does the same for the 40mm pipe on a sink, bath or shower. Both come in black and white.

Clip waste pipe every 500mm horizontally and every 1.2m vertically, with a clip within 150mm of each fitting. Both clips are in the solvent weld waste category.

Are push fit and solvent weld pipe the same size?

Both are sold as 32mm and 40mm, but the true outside diameters differ. Measured across the outside, push fit pipe is about 34mm and 41mm, and solvent weld pipe is about 36mm and 43mm. Each system takes its own fittings, so use push fit fittings on push fit pipe, and solvent cement with solvent weld pipe and fittings.

To tell what is already on the wall, look at the socket. A push fit socket is bulky, with a visible cap and a rubber seal inside. A solvent socket is short, plain and glued. Where the two systems meet mid-run, ask us for the changeover fitting. A reducer from 40mm to 32mm comes in both systems, so buy the one that matches the fitting it goes into.

What do I buy for a basin?

A basin takes 32mm pipe. For a push fit run you need:

As an example, take a basin 1.5m from the stack. That is inside the 1.7m longest branch. One 3m length is cut to fit, and 1.5m at 500mm spacing takes three clips, with one more within 150mm of each fitting.

What do I buy for a kitchen sink?

A kitchen sink takes 40mm pipe. For a push fit run you need:

Take a sink 2.4m from the stack, inside the 3m longest branch. One 3m length covers it, cut to size. At 500mm spacing, 2.4m takes five clips, plus one within 150mm of each fitting.

Cut each pipe square and chamfer the edge before pushing in, so the seal stays seated. For a run that will be buried or boxed in, the solvent weld range has the same pipe, bends, branches and reducers, glued with solvent cement.

What to buy

Stuck on your own house? Every roof is different. Ring 0151 525 4488 and describe it. We do this all day.

More guides